Talc Hammer Mill

Introduction of Talc Hammer Mill

talc hammer mill

Clirik talc hammer mill is widely used for micron powder producing.It is suitable to grind the material with middle and low hardness, moisture below 6%, and the material should be non-explosive and non-flammable, such as: calcite, chalk, limestone, dolomite, kaolin, mica, magnetite, vermiculite, meerschaum, gypsum, graphite, fluorite, phosphate ore,potassium ore pumice, etc.

Application of Talc Hammer Mill

Hammer mill is engaging in crushing various rocks and stones with comprehensive strength not higher than 320 MPa into coarse powder and small particles, it is widely used in metallurgy, mining, chemical, cement, coal, sand-making, coal gangue, construction, refractory materials and ceramic industries.

Working principle of Talc Hammer Mill

Hammer Mill mainly consists of frame, rotor, support iron and grate bars. The frame is divides into two parts: upper part and low part, which are welded by steel plates after being cut. Liners made of high manganese steels within the frame can be replaced after being worn out. The rotors consist of turnplates, pin shafts, and hammers which are grouped regularly in the main shaft. The main unit drives the main shaft through the motor and triangle belts, which, in turn, rotates the rollers. Large materials entering the crusher through the feed inlet are firstly crushed by the high-speed hammers, and the thrown fiercely to the support iron for further crushing. Qualified materials crushed will be screened out and exit from the gap of the grate bars while the unqualified will be left in the crushing cavity to be further hammered and ground until reach the standard size. The size of the final product can be adjusted by changing the grate bars. The gap between the rotors and the grate bars can also be adjusted according to different requirement. To avoid the plugging of the crusher, the proportion of water for the crushing material is no more than 20%.

Advantages of Talc Hammer Mill

1. Uniform particle size with high crushing and crushing ratio

2. High capacity and low power consumption

3. Simple structure; Easy operation

4. Low investment and environmantal-friendly

 

Technical Parameters of Talc Hammer Mill

Type

PC400x300

PC600x400

PC800x600

Rotor Diameter /mm

400

600

800

Rotor Width/ mm

300

400

600

Rotor Speed/ r/min

1100

1000

900

Max Feeding Size/mm

<100

<220

<350

Finished particle size /mm

0-10

0-20

0-22

Capacity / t/h

3-8

8-15

15-45

Power /kw

11

18.5-22

45

Hammer Number /pieces

12-16

12-20

20-28

Dimension L*W*H/mm

855*795*860

1150*1095*1230

 2360*1490*1415

 


Copyright 2015 by Shanghai Clirik Machinery Co. LTD All rights reserved